ИССЛЕДОВАНИЕ АНИЗОТРОПИИ СВОЙСТВ ПОЛИКРИСТАЛЛА НА ОСНОВЕ ТЕКСТУРНЫХ ДАННЫХ

Resultado de pesquisa: Articlerevisão de pares

Resumo

Yeltsin Ural Federal University; ul. Mira 19, Yekaterinburg, 620002, Russia; e-mail: avstep@mail.ru The results of studying correlation between the crystallographic texture of polycrystalline materials and anisotropy of their physical and mechanical properties are considered. The methods for calculating the anisotropic properties of polycrystals based on the data obtained by X-ray methods of direct and inverse pole figures are reviewed. Calculation methods based on the use of the distribution function of crystallite orientations require the use of a large amount of experimental data and, hence, they are not suitable for express estimation of the anisotropy level of the physical properties of samples upon their thermomechanical processing. A method for rapid estimation of the anisotropic properties of the sample based on the use of Δi («orientation factors») in the calculations, is proposed. Experimental data of X-ray analysis (method of inverse pole figures) are used to calculate the absolute and relative deviations of the physical parameter of textured polycrystal from the same value in the isotropic sample. The contributions of individual crystallographic orientations to the formation of the anisotropy of the properties of the sample are estimated. The dynamics of quantitative changes in the anisotropic properties of a polycrystal in the process of texture formation is studied. To analyze the source of the most rapid changes in the anisotropy of properties, we used the coefficients of the «response» matrix, the calculation of which does not depend on the results of specific diffractometric measurements, but is common for all metals with a hexagonal close-packed (hcp) lattice. The anisotropy of the coefficient of thermal conductivity, electrical conductivity, and thermal diffusivity was calculated for the samples of deformed yttrium which underwent cold rolling with a reduction ratio of ε = 25%. It is shown that the final physical properties of the hcp polycrystal are largely determined by the pyramidal crystallographic orientations {1015}, {1124}. The results of the study form a basis for analysis of the anisotropy of the physical properties of hcp-metal samples upon thermomechanical processing.
Título traduzido da contribuiçãoStudy of the anisotropy of the polycrystal properties based on texture data
Idioma originalRussian
Páginas (de-até)46-51
Número de páginas6
RevistaЗаводская лаборатория. Диагностика материалов
Volume85
Número de emissão9
DOIs
Estado da publicaçãoPublished - 2019

GRNTI

  • 81.00.00 GENERAL AND COMPLEX PROBLEMS OF TECHNICAL AND APPLIED SCIENCES AND BRANCHES OF THE NATIONAL ECONOMY

Level of Research Output

  • VAK List

Impressão digital

Mergulhe nos tópicos de investigação de “ИССЛЕДОВАНИЕ АНИЗОТРОПИИ СВОЙСТВ ПОЛИКРИСТАЛЛА НА ОСНОВЕ ТЕКСТУРНЫХ ДАННЫХ“. Em conjunto formam uma impressão digital única.

Citar isto