МИКРОСТРУКТУРА И МЕХАНИЧЕСКИЕ СВОЙСТВА ВЫСОКОПРОЧНОЙ МАШИНОСТРОИТЕЛЬНОЙ СТАЛИ МАРТЕНСИТНОГО КЛАССА

Resultado de pesquisa: Article

Resumo

A promising martensitic steel with high hardenability was studied. In the range of cooling rates 0.1…30 °C/s the only one transformation was registered by the dilatometer starting at a temperature of M s = 355 ± 10 °C. The microstructure and mechanical properties of the studied steel were analyzed after various heat treatment modes: cooling from austenitizing temperature with various rates (from 0.02 to 20 °C/s), austempering at a temperature 280…380 °C, oil quenching and tempering at a temperature 200…600 °C. It is shown that a 1000-fold change in the cooling rate weakly affects the strength of the studied steel. The bainitic transformation in the steel under consideration occurred in the temperature range of the martensitic transformation, which led to a decrease in impact toughness compared to the fully martensitic microstructure both after slow cooling and austempering.
Título traduzido da contribuiçãoMICROSTRUCTURE AND MECHANICAL PROPERTIES OF MARTENSITIC HIGH-STRENGTH ENGINEERING STEEL
Idioma originalRussian
Páginas (de-até)41-49
Número de páginas9
RevistaМеталлург
Número de emissão7
Estado da publicaçãoPublished - 2020

GRNTI

  • 53.00.00 METALLURGY

Level of Research Output

  • VAK List

Impressão digital Mergulhe nos tópicos de investigação de “МИКРОСТРУКТУРА И МЕХАНИЧЕСКИЕ СВОЙСТВА ВЫСОКОПРОЧНОЙ МАШИНОСТРОИТЕЛЬНОЙ СТАЛИ МАРТЕНСИТНОГО КЛАССА“. Em conjunto formam uma impressão digital única.

Citar isto