МОДЕЛИРОВАНИЕ УГЛОВОГО ПРЕССОВАНИЯ ПОЛОСЫ В 3D ПОСТАНОВКЕ

Resultado de pesquisa: Articlerevisão de pares

Resumo

The results of modeling of angular extrusion by the finite element method are presented in the DEFORM software module. The difference of the solution is the three-dimensional formulation of the problem for the case of pressing magnesium. This made it possible to reveal heterogeneities in the distribution of strains and stresses. It was concluded that the strains at the upper edge of the pressed strip increased to 40% relative to strains at the lower edge. An increase in the level of hardening on the edges of the strip was also revealed, which will have to be taken into account during the subsequent sheet rolling.
Título traduzido da contribuiçãoAngular strips extrusion modeling in 3D setting
Idioma originalRussian
Páginas (de-até)33-37
RevistaКузнечно-штамповочное производство. Обработка материалов давлением
Número de emissão9
Estado da publicaçãoPublished - 2019

GRNTI

  • 55.00.00 MACHINE ENGINEERING

Level of Research Output

  • VAK List

Impressão digital

Mergulhe nos tópicos de investigação de “МОДЕЛИРОВАНИЕ УГЛОВОГО ПРЕССОВАНИЯ ПОЛОСЫ В 3D ПОСТАНОВКЕ“. Em conjunto formam uma impressão digital única.

Citar isto