ФОРМИРОВАНИЕ ДЕФЕКТНОГО СЛОЯ ПРИ ЛЕЗВИЙНОЙ ОБРАБОТКЕ ХРУПКИХ МАТЕРИАЛОВ

科研成果: Article同行评审

摘要

Parts made of modern brittle materials with high quality finish are widely used in manufacturing of optical and electronic devices as well as crucial assemblies in mechanical engineering products. Diamond machining enables generation of geometry without affecting the functional surface layers by heat. At the same time, brittle material cutting is accompanied by the formation of a defective layer on the machined surface due to the structural disturbances in the material caused by the applied cutting force. The paper discusses causes and the mechanism of the defective layer formation on the machined surface during non-free cutting of brittle materials and examines ways of reducing the size of the defective layer. Theoretical and computer-aided analysis is performed to determine the impact of the local stresses field in the zone of concentrated pressing force acting on the brittle plate surface. Using experimental methods, a defective layer formed after cutting notches on a silicon plate by a diamond tool is studied.
投稿的翻译标题Formation of a Defective Layer when Machining Brittle Materials
源语言Russian
页(从-至)10-16
期刊Известия высших учебных заведений. Машиностроение
5(710)
DOI
Published - 2019

GRNTI

  • 55.00.00 MACHINE ENGINEERING

Level of Research Output

  • VAK List

指纹

探究 'ФОРМИРОВАНИЕ ДЕФЕКТНОГО СЛОЯ ПРИ ЛЕЗВИЙНОЙ ОБРАБОТКЕ ХРУПКИХ МАТЕРИАЛОВ' 的科研主题。它们共同构成独一无二的指纹。

引用此